@heyitskjI don’t think there’s anything wrong with your bed levelling. Even though the prints are bad, they are consistent over the entire bed/print a…

@gregorybarrett1983 The best way to get this right is to set the Z-offset to zero. Home all axes, then move the Z axis (nozzle) to zero. Slide a p…

I agree with the other commenters, it sounds like there’s something wrong with the extruder.Most likely the arm is cracked, which you can’t see from a…

This could be a calibration issue as mentioned above, but it’s so inconsistent, I’m more inclined to think that belts and eccentric nuts may need adju…

It doesn’t seem to me that the BLTouch is faulty, it appears to be doing what is expected but the firmware is preventing completion for whatever reaso…

The slicer doesn’t account for settings within the printer. It assumes that if it tells the printer to go to zero, that’s where it will go, it then bu…

If you select Standard Quality – 0.2mm, Cura will always produce Gcode to produce 0.2mm layers, but you can change the 1st layer to something else if …

What did you do exactly when you upgraded to direct drive?Possible the stepper or connectors are faulty or have a short.Did you upgrade any firmware?

AFAIK there’s no RS232 connector or facility on a 4.2.7 board.I have one right in front of me and I can’t find one. I don’t believe it exists. 🙁

That is a very old version of Cura and Creality haven’t kept up with the new versions. Cura is now at v4.8 which loads fine on Windows 10 for me and…

There are literally hundreds of cables available on Amazon.Do a search for USB A to Micro USB cable. The reason they don’t work is because you ha…

I’ve been following this subject in various places for months and there appears to be no easy solution.Advice I’ve been given is to cut the end of the…

@stresspuppyOne of the problems with over-extrusion is that one layer may appear to go down perfectly, then the next layer is over extruded and ‘flatt…

@stresspuppyAs per the video:The adjustment is done on a very tiny potentiometer, one for each Vref. You have to be quite gentle as they’re delicate…

Firstly I would check Vrefs on the new board. Quality control does not seem to be good and my Vrefs were way off on a new 4.2.7 board. I set mine to t…