Last seen: Oct 15, 2021
One thing – did you “save” the settings for the BLTouch after you got things set? And then you powered down? Did you have an SDCard in the slot? I…
Don’t know about your issue – but I had massive layer shifts, and “knocking” noise from the printer with the 4.2.2 board about 2 weeks after getting i…
I’ve had the same thing – and power gets bad at my location this time of year. Lots of “micro” power hits, and brownouts. I had so much electronic s…
This! I had the same problem couple days ago. Had to rename to something like “firmware3.bin”. Make sure card is no larger than 8GB – seems firmwar…
@kevin I agree – plus less clean up afterwards. Sorry – I’ve been unable to login for days, and even now, most of the login page is in Chinese. A…
Extruder works fine. I can immediately shift to another PLA/PLA+ filament – and it prints without issue at that point. Seems to be strictly related …
Another thing – is your print shifting on your bed – or is the bed adhesion solid? That was my first problem – spent a week (off and on – gotta work …
@kikko – have you checked belt tension, etc.? My 4.2.2 board looked like your newer result (right pic) – somewhat worse before I got the 4.2.7 and in…
@hantuuk – I got a 4.2.7 board, and even without using the grounding harness – shifting problems were resolved immediately. After maybe 30 hours of p…