Hi @maikonssilva yea, some users do the mod to connect the main board fan to steady-on 12V on the board and disconnect so the main board fan from t…

Hi @jgill, for a good first layer bed leveling is the clue (seek for a good manual mesh bed leveling Firmware, but read enough before installation of …

@kevin, @ventura_kid I have learned from Creality that only the part cooler fan can be controlled by the slicer SW (from 0..100%). So the heatbreak c…

Hi @mrisco, did you install this bin on your 4.2.2 e3V2? Marlin open source licence ok ? Is there any need to update DWIN_SET for the LCD display …

Hi @yvonh thank you very much for the information. I want to do the same and fully agree with your opinion about the trinamic driver. Board ground…

Hi @tundrwd @kevin I also had emails back and fort with Creality about ESD. That could be really an issue with the plastic belts with no connection …

@derbydx Another thought: Check whether the toothed belt is intact over the whole length or whether the gear on the Y motor is still properly attach…

@derbydx, huh, there should be no jam, also no mini jam. Could be that stepper motor channel (driver on mainboard, wires, motor itself). Did the init …

HI @3nderuser, yes complete with you…it it too much, however it could start right after start, see picture. But I think is not the cause here you’r…

Hi @3nderuser, yes strange when it would occur so fast. I’m not sure if creality reduce stepper motor current when motor is initialised but in hold po…

Hi @derbydx , according your pictures looks like layer shift which seams to be an issues with some 4.2.2. mainboard. Pls find another thread right her…

I got the same video by creality (dangerous performance with a knife..) to show me how I could attach the housing better to protective earth. The scre…

@daveyman123 I calibrate my extruder in such a way, that I screw off the bowden tube a the extruder, insert a filament, cut it exactly a this outlet…

Hi @johnny55, how do you do with the glasbed now? An another thought came up: we got the glasbed with a thiny protective foil from stock. Did you remo…