tombogan03884
Active Member
Joined: Jun 7, 2021
Last seen: Jun 16, 2021
Last seen: Jun 16, 2021
Follow
RE: Ender 3 Pro reboots
Thank you VERY MUCH ! Seems to be the heated bed wiring. I will replace that. Thank you again.
2 years ago
Forum
RE: how to get tube to stay connected at the top where the filament enters?
? Experience, the best, and least forgiving, teacher. ?
2 years ago
Forum
RE: Ender 3 Pro reboots
@kevin Oh THANK YOU ! Getting closer to the problem. I tried pre heat hot end to pull out the filament with no problem. When I tried “Pre He…
2 years ago
Forum
RE: how to get tube to stay connected at the top where the filament enters?
@kevin Especially with my limited experience. Guess how I found out about it LOL. Left for a while and came back to 3 feet of filament between th…
2 years ago
Forum
RE: how to get tube to stay connected at the top where the filament enters?
@tlhlane Hey, finally one I can answer ! those little blue clips are important . they wedge between the screw in part, and the push in part …
2 years ago
Forum