Forum


 

tangerine
tangerine
@tangerine
Trusted Member
Joined: Feb 21, 2021
Last seen: Jul 2, 2022
Topics: 0 / Replies: 87
Topic
Forum
Replies: 1
Views: 330
Topic
Forum
Replies: 1
Views: 290
Topic
Forum
Replies: 1
Views: 430
Reply
RE: Pause/Change Filament

Sorry for not replying earlier but I don’t seem to be getting e-mail notifications anymore. I tried using the modify G-Code option but when I printe…

10 months ago
Forum
Reply
RE: Pause/Change Filament

It’s been a while since I have been on here mainly due to studying (an entirely different subject) but I was just trying to design a little tool and n…

10 months ago
Forum
Reply
RE: Filament extruder

@kevin I was about 2m from disaster!

1 year ago
Forum
Reply
RE: Filament extruder

I just noticed a loud snapping noise part way through a pretty big print. It was the filament reel jerking quite intensely. I looked at the filament a…

1 year ago
Forum
Reply
RE: Banding problem

@mbbrewerca Yes, it is much easier but who can wait another ten minutes after a 12 hour print?! ? I’m in there with a hammer and chisel as soon as …

1 year ago
Forum
Reply
RE: Banding problem

@mbbrewerca It was the top belt (I’m not sure if it is X or Y but I’m printing right now so don’t want to interfere) but I think that the difference i…

1 year ago
Forum
Reply
RE: Banding problem

I fitted the squash ball feet and did another test print which was pretty much identical to the first test print I posted – so had little or no effect…

1 year ago
Forum
Reply
RE: Banding problem

I downloaded it off Thingiverse. I’ve looked at it and can’t see anything wrong with it and nobody has said anything in the comments about this kind o…

1 year ago
Forum
Reply
RE: Banding problem

I tried a test print and there does not seem to have been a problem – see enclosed photo. I forgot that I had ironing on which accounts for the messy …

1 year ago
Forum
Reply
RE: Banding problem

@kevin I am using a Cura profile which was created using the process I found elsewhere and posted in another thread. When I first used it, I noticed t…

1 year ago
Forum
Reply
RE: Banding problem

@mbbrewerca As I mentioned, it didn’t do it on the previous or subsequent prints but the subsequent print wasn’t very high. I just checked the belts…

1 year ago
Forum
Topic
Forum
Replies: 13
Views: 365
Page 1 / 6