Forum


 

Stephen
Stephen
@stephen
Active Member
Joined: Jan 3, 2021
Last seen: Jan 13, 2021
Topics: 0 / Replies: 12
Reply
RE: E3v2 Digs into Build Plate when Printing

Adjust the z offset. And the level again I recommend this to help level

2 years ago
Forum
Reply
RE: first line printed at the edge of bed

I’m pretty new to this also and the learning curve is steep. Once you get it dialed in then the hardest part is deciding what to print and then waitin…

2 years ago
Forum
Reply
RE: Ender 3 v2 Firmware to support 400mm x 400mm with Creality BL Touch installed

I would try here. they don’t have one already built but when you buy the one year subscription for $15 (aud) a year you also get “credits” which yo…

2 years ago
Forum
Reply
RE: LCD Control M117/M73 with Octoprint

I’m about to tackle the octoprint on my 3 v2 .. from what I can tell you can’t have it display messages from octoprint onto the built in LCD that come…

2 years ago
Forum
Reply
RE: Ender 3 Pro BL Touch Labled FW

No. If you try and use it without one it won’t work and vice versa, if you use a firmware that doesn’t have bltouch but have one it won’t work. Th…

2 years ago
Forum
Reply
RE: Print not sticking ?

I was having the same problems. Did a couple things and now it’s like butter. These help: 1) Start by having a clean plate each time. 2) Lev…

2 years ago
Forum
Reply
RE: first line printed at the edge of bed

This is the “test print line”. It’s really to get the juice flowing from the nozzle and help knock down any extra material that happens during head wa…

2 years ago
Forum
Reply
RE: ender 3 v2 bltouch not working and now dead..

Fyi.. after playing around with my printer more there are other nice things with the firmware that I got from the site I linked. 1) does the 9 points…

2 years ago
Forum
Reply
RE: ender 3 v2 bltouch not working and now dead..

@bigheph I didn’t see your post but yes this worked. Got the firmware for the ender 3 v2 with bltouch. Worked great. See my other post in this thread…

2 years ago
Forum
Reply
RE: ender 3 v2 bltouch not working and now dead..

Figured it out… wrong firmware .. go there .. you will need a subscription to download (15 aud for a year). There is one for the 3 v2 specifically…

2 years ago
Forum
Reply
RE: ender 3 v2 bltouch not working and now dead..

No one can help? I’m trying to reach out on facebook also for support. Is there a better method for getting support for the firmware and bltouch stuf…

2 years ago
Forum
Topic
Forum
Replies: 10
Views: 3191