Forum


 

Senekal
Senekal
@senekal
Active Member
Joined: Feb 24, 2021
Last seen: Mar 22, 2021
Topics: 0 / Replies: 10
Reply
RE: Successful prints = 0

Glad to be a bit of help! I actually struggled a bit to find good advice on retraction settings over (literally) the last few days. Finally figured it…

2 years ago
Reply
RE: Successful prints = 0

Stringing is best managed with the extraction settings in the ‘Travel’ sector of Cura. I’m running a regular Ender 3 and just finished dialing in my o…

2 years ago
Reply
RE: Ender 3 Pro, Filament Exploding out of the back of Extruder Head?

In addition to the tube fitting into the metal throat, I would look at replacing the nozzle. They’re cheap and replacing them often helps.It seems odd…

2 years ago
Reply
RE: Silent Board Upgrade

Yep, although I don’t think it actually makes much difference which one you put where. I did my silent board upgrade a few days ago and used the conne…

2 years ago
Reply
Answer to: Ender 3 Stepper Motor issue

Well I have replaced the main board and the problem is (almost) gone. I think the issue may be partly that there is jamming up toward the hot end.The …

2 years ago
Reply
RE: Extruder motor twitching

I’m having a similar issue – in my case it is the main board that’s the issue. My unit is several years old though.A good test is to do a ‘cable swap’…

2 years ago
Reply
Answer to: Ender 3 Stepper Motor issue

I wondered about that too as the tension on the metal extruder seemed higher and I thought that this might put more wear on the motor. It worked both …

2 years ago
Reply
RE: Ender 3 Stepper Motor issue

Thanks for the info!Turns out – definitely not the motor. I bought a new motor, did exactly the same thing. Changed the cable – still the same thing. …

2 years ago
Topic
Replies: 5
Views: 2873