@micahsteeze Have you calibrated your extruder? It may be extruding too much filament.

@burgo855 Did you try increasing bed temperature? I have to run my glass bed (smooth side) at 65°C to get consistent adhesion.

@flashko Did you try turning the Z motor with the power off and cable disconnected? More likely the Z motor driver was damaged rather than the Z moto…

@teamcline831 Looks to me like your nozzle is too far above the bed. I believe that the three lines printed by the slicer should probably be melded t…

@renaud88 I have only been printing on an Ender 3 for about three months now, but at a guess, I think your issue may be related to missing supports. …