Skip to content

Forum

 

Pauljp
Pauljp
@pauljp
Active Member
Joined: Sep 6, 2021
Last seen: Nov 15, 2021
Topics: 0 / Replies: 9
Reply
RE: Ender 3 Prints too high on z access

Seems to me that you need to adjust the steps/mm for the z axis. What I do is tape a needle horizontally to the hot end shroud, clamp a ruler standi...

11 months ago
Reply
RE: Ender 3 Pro Y axis Shuddering/problems

Follow the Y axis motor cable to the motherboard underneath. The connection may not be entirely seated in its socket. You will also have to remove the...

11 months ago
Reply
RE: Ender 3 Pro - Layer Gaps

@shigadeyo Good to know. Thanks for sharing with us.

11 months ago
Reply
RE: Under Extrusion Please Help!!!

How is the tension on your extruder gears? Could it be slipping on certain filaments? I am also wondering about the thermistor on the hotend. If it ...

11 months ago
Reply
RE: Under Extrusion Please Help!!!

Under extrusion is usually caused by your e-steps not being set up properly. Did you calibrate it by measuring 100mm and then feeding 100mm through ...

11 months ago
Reply
RE: Filament problem

Sounds like you have a clog in the nozzle. Did you try cleaning it with the needle that came with your unit? You can also try a cold pull or change th...

11 months ago
Forum
Reply
RE: Ender 3 Max brand new not printing

@mojavegomez Perhaps your Gcode file is not right. I included a simple gcode file that prints a thin center disk in the middle of the bed. Copy it to ...

12 months ago
Forum
Reply
RE: Firmware will not update

Well after staying awake all night thinking about this, I found the solution. My SD cards that I was using (1,2,64GB) were not able to be formatted to...

1 year ago
Forum
Topic
Forum
Replies: 2
Views: 836