Forum


 

校工叔叔(Mr. Au)
校工叔叔(Mr. Au)
@nice
Eminent Member
Joined: Oct 27, 2020
Last seen: Oct 19, 2021
Topics: 0 / Replies: 45
Reply
RE: CR-X test files

Benchmark files are everywhere on the internet. Look for Benchy boat, calibration test, string test, overhang test, temperature tower.. etc some of…

1 year ago
Forum
Reply
RE: Vibration on hotend

It’s possible that screws when loose over time as these machines involve a lot of movements. Try determine where the noise came from then check nearb…

1 year ago
Forum
Reply
RE: Upgraded Touch Panel Screen Display adaptable for Ender 5

I don’t think it’s available. They had a livestream about the touch display sometimes ago. I remember they said it’s for Ender3, 3X, 3Pro.. I then a…

1 year ago
Forum
Reply
RE: Need Z align every time i print

When I first got my 6SE, the z offset(or any other settings) couldn’t survive thru reboot. It lost it’s setting every time the printer reboot. Creal…

1 year ago
Forum
Reply
RE: Ender 3 v2 Hot stepper motors

Have you look at Ender-7’s extruder motor setup? They add a fan to it to cool it down.. check it out and it might give you an idea on how you can mod…

1 year ago
Forum
Reply
RE: CRX troubleshooting – Potential heat creep?

as mentioned above, it’s highly fan related issue.. Is your side fans working? I had similar clogging issue when my side fans are not working. My …

1 year ago
Reply
Answer to: Y Axis bearings balance?

Sharing my similar story. I have 2 machines that the nuts went loose after few months of usage which causing unbalance bed, I just tight all of them …

1 year ago
Reply
Answer to: What could cause my ender 3 pro with 4.2.7 board and bltouch to not not level or print?

It looks like to me that the right side of the bed is perfect, but you need to raise the left side of the bed. Even with bl-touch, you still want to …

1 year ago
Reply
RE: What do you think about Ender 7?

My concern about Ender 7 is the nozzle. It said one of the trick for this machine to achieve high speed printing is by implementing a customized high…

1 year ago
Forum
Reply
RE: Broken 3 pin connector

I don’t think Creality will sell just that plastic connector. Closest I can find is this, the whole wire with the connector. However, this is Cr…

1 year ago
Reply
RE: can’t get hot end apart…

Try to do it from the nozzle if the pneumatic joint is clipping it too hard. First detach the tube from the extruder side where it feed in. Then he…

1 year ago
Forum
Reply
RE: Still USB Problems

I do this with just a piece of tape.  Untitled.png

1 year ago
Forum
Reply
RE: Print bed collides with power supply, unable to level bed

I did have the same problem at my school’s Ender 3 Pro. Like Kevin said, adjust the z limit switch.

1 year ago
Reply
RE: Cura plugin to “test fit” model to use the least amount of filament?

I am not aware of such plugin, but there are tons of plugins for Cura and I don’t know every single of them. No matter how you position the model, i…

2 years ago
Reply
RE: Problems printing with iSANMATE 80/20 PLA+/Wood filament

I miss the point where you said wood filament on your original post. I never print wood filament but I remember reading about it awhile ago. Like Ke…

2 years ago
Page 1 / 3