Forum


 

NateZLG
NateZLG
@natezlg
New Member
Joined: Dec 15, 2021
Last seen: Dec 15, 2021
Topics: 0 / Replies: 4
Reply
RE: Filament stop feeding in the middle of the print.

Is the filament hard to remove after it stops extruding? If the extruder fan is under performing it’ll allow heat up into the heat brake; the filament…

1 year ago
Reply
RE: Ender 3 motors frozen after upgrade

I can’t speak to the motor issue, but I know the board will ignore firmware if it’s already seen the file name. Change the file name and it should re-…

1 year ago
Reply
RE: New ender 3 auto homing not working

It sounds like it’s not triggering the X limit switch. I’d check the limit switch wiring connections to start with.

1 year ago
Reply
RE: Ender 3 V2 Multiple Items

Here’s my list for bed adhesion problems. I won’t go too in depth on each since there are plenty of better resources, you often just need the right ke…

1 year ago