Forum


 

MrPig
MrPig
@mrpig
Active Member
Joined: Dec 19, 2020
Last seen: Feb 16, 2021
Topics: 0 / Replies: 6
Reply
RE: Ender 5 BL Touch Installation Tutorial

@tedro7777 the photo of the 3-pin and 2-pin connections that i supplied is the documentation. there is an empty 5-pin connector on the main board. y…

2 years ago
Reply
RE: Ender 5 BL Touch Installation Tutorial

@tedro7777 Yes, G29 code does auto-bed leveling before printing. One last thing, you will have to set the Z-offset in the bed-leveling section… …

2 years ago
Reply
RE: Ender 5 BL Touch Installation Tutorial

@tedro7777 here is the diagram for wiring to main board directly. note: the 3 pin connector has been rewired.  v4.2.2-with-BLTouch-No-Ada…

2 years ago
Reply
RE: Ender 5 BL Touch Installation Tutorial

Oops…that implies that you are using the adapter card. I didn’t, as it was kind of crap. Here’s the one without the adapter card. To use this o…

2 years ago
Reply
RE: Ender 5 BL Touch Installation Tutorial

@tedro7777 it appears that creality.com has updated their site. Here is the file that I downloaded from the site last year. You will need to add G…

2 years ago
Reply
RE: Ender 5 BL Touch Installation Tutorial

@drunkaard have you had any success on resolving this issue? I have the identical setup and the Z axis will not move. apparently the 3 pin connecto…

2 years ago