Forum


 

mlogue9
mlogue9
@mlogue9
Active Member
Joined: Jan 29, 2021
Last seen: Mar 8, 2021
Topics: 0 / Replies: 15
Reply
RE: Ender 3 Pro wont store settings

Ever hear of EEPROM or NVRAM, folks? I have frequently swapped out SD cards and lost quite a few. Dumb idea storing machine settings on removable medi…

2 years ago
Reply
RE: Proper Bed Cleaning?

I also advice against ever using scraping especially with a harder tool than the surface. I found that printing a sheet – just a huge 2 layer raft …

2 years ago
Reply
2 years ago
Reply
RE: First layer of print melting onto print surface.

Not a fan of glass, my issue either it sticks like hell or slides off once you leave the room while printing. What are you using for initial layer spe…

2 years ago
Reply
RE: Ender 3 Pro Z-Axis Motor

Stock creality printer? That is odd. I had to re-route my wires and make sure there were no snags. Other than that someone maybe made a mistake. Obvio…

2 years ago
Reply
RE: BL Touch, Z axis not lowering.

Did you swap the + and ground pins or ensure they were properly oriented with screenprinting V and G respectively on board? I didn’t understand why it…

2 years ago
Forum
Topic
Replies: 1
Views: 190
Topic
Replies: 1
Views: 191
Topic
Replies: 1
Views: 233
Reply
RE: Vaporized filament PLA+

Bit embarrassed. It was a knot in the spool! I wasn’t used to the resiliency of PLA+ and it snapped back into the darn reel and I must of pulled it …

2 years ago
Topic
Replies: 3
Views: 222
Reply
RE: Ender 3 Pro – Forgets Z offset and wrecks bed

Solution – move Z end switch. It wasn’t solution i wanted but it does the job.

2 years ago
Topic
Topic
Replies: 3
Views: 507