From what I’m seeing in the video, it appears that the print head is in the home position, then does a purge line, and then starts to move to the cent…

I agree with @stesmith74. I’ve been running my Ender 3 with a Noctua fan on each my main board and on my hot end, each with buck converters. The dif…

Hi @ga1lyons. Is this a new issue, or a new machine? It’s possible that the fan cover or blower fan are not fully tightened? Perhaps take the hex w…

Thanks for the update! I’m glad to hear that things seem to be ok now. As for the print lifting off after the bed cools, that’s a great feature of so…

Based on your photo, I’d suggest the same as @kevin. I would suggest heating the hot end first and using some pliers to pull the filament out. If th…

Sorry that I missed that part. Like you identified, it could very well be that the desk was bumped. The best bet would be to give it another try. If …

Does it happen on the same height during different prints? It could be that the belt might be loose on one of your axis. When I hit that type of pro…

Bonjour. Excusez mon français (Je ne parle qu’un petit peu le français). Voici un guide pour ajuster le z-offset, mais il est en anglais. est-ce que …

I see that someone else did work out what had to be done to get the CR-10s with bltouch here on the Forums: As for the Micro Swiss, I’ve done some …

Has it been this way since you bought the machine, or is this a new issue? Trying to figure out whether it’s a hardware software, or g-code issue.