Last seen: Jun 2, 2023
@kata Then I’m sorry that there’s nothing I can do about it. But your case was sent back to the Creative Technology team and they send me this.
@kata I agree.
@waffles101el Did you use a “raft” in slicing software?
@kata Many people can’t use vase mode on ender6. Please use this setting. 0.1mm-中文-En6.rar
@3d-printt You are welcome! Enjoy your printing.
@desiv About the thermal runaway thing, you can check out this video with some simple ways to test it./p>
@andre0815 It is probably an extruder issue. Please check the extruder gear and guide wheel.
@stemy You can lower the temperature of the hot nozzle a little.
@supremveiorel It seems to be a problem with the program, have you ever tried to re-flash firmware.
@albprintin Do you mean that you can not adjust the Z offset when you live and printing the brim? I would like to say how did you determine that it di…
@waffles101el First, you could level your bed better, make the bed closer to the nozzle. Then I think your print has a small touch area on the bed,…
@fluffie-taz Hi, Chris. You are welcome. Hope you could fix the issue soon.
@everettg03 There are many people got the same issue. You may find some tips here.
@3d-printt The eccentric nut is adjustable and you may need to adjust it. Secondly, you probably don’t have to care that much because you haven’t fin…
@3d-printt The eccentric nut is adjustable and you may need to adjust it. Secondly, you probably don’t have to care that much because you haven’t fin…