Skip to content

Forum

 

holmes4
holmes4
@holmes4
Trusted Member
Joined: Mar 27, 2021
Last seen: Aug 27, 2022
Topics: 0 / Replies: 95
Reply
RE: Filmament Change on Every Print

There is a menu setting to turn the filament sensor on or off - I think it's under Calibration. You should do extrusion calibration -is a good refe...

1 month ago
Forum
Reply
RE: No luck on more delicate prints

First, I'd say your bed isn't level. You can see the difference in "squish" on the skirt line from left to right. Second, this particular print requir...

1 month ago
Forum
Reply
RE: Ender 3 Max and BL Touch issue

CRtouch and BLtouch are identical as far as firmware is concerned.

1 month ago
Forum
Reply
RE: Ender 3 Max Neo

I would not expect any new profile to be needed, since the only changes on the Neo are things that wouldn't impact the slicer. Try profiles for the 3 ...

1 month ago
Forum
Reply
RE: Ender 3 max consistant bump at every layer

This most often happens when you have an SD card inserted and have powerfail recovery enabled. This causes the printer to write a "checkpoint" to the ...

1 month ago
Forum
Reply
RE: Max Misaligned out of Box

This can happen even for a brand new printer - it did for mine. The issue is that the vertical extrusions need to be square and parallel, and they oft...

1 month ago
Forum
Reply
RE: Firmware for printing at higher temps on Ender 3 Max with CR Touch?

It's just a constant defined in the Marlin configuration.h. You can build Marlin yourself (I explain how in this thread). In the Marlin source, BLTouc...

4 months ago
Forum
Reply
RE: Ender3 MAX and Creality Sprite Hotend

Why not build your own firmware, so you can set the max temp and probe offsets any way you like? I have a thread in this forum on the process.

5 months ago
Forum
Reply
RE: Switching menus on the printer

All I can say is that this is not normal.

5 months ago
Forum
Reply
RE: Building Marlin 2.0 for the Ender 3 Max

@shortass1234 You can try the attached - I don't have a 4.2.x board anymore so I can't try it myself. If you'll post the error messages, I may be able...

5 months ago
Forum
Reply
RE: Building Marlin 2.0 for the Ender 3 Max

@vfdragon4 It looks as if you put those files in the higher level folder. You want them in the folder just named Marlin, which is under Marlin-2.0.x.

5 months ago
Forum
Reply
RE: CR Touch failing

That the probe retracts by itself is the first thing to look at. I have a BLtouch and know that the magnet is adjustable with a hex wrench from the to...

6 months ago
Forum
Reply
RE: when the hotend starts to heat up. the printer starts beeping

Yes, the Max shares many components with the Ender 3, including the hotend, heater and thermistor. Did the display show reasonable temps up to the 5...

6 months ago
Forum
Reply
RE: Building Marlin 2.0 for the Ender 3 Max

The line you want to change is in platformio.ini, which is in the folder level above Marlin. The section of that file should look like this: [plat...

6 months ago
Forum
Reply
RE: Compatible Hotend and Thermistor for Ender 3 Max

I used the Gulf Coast Robotics hotend for a while. It is a mount and size match for the Creality hotend and worked fine. Really, any of the hotends th...

6 months ago
Forum
Page 1 / 7