Forum


 

gmergulhao
gmergulhao
@gmergulhao
Active Member
Joined: Dec 30, 2020
Last seen: Apr 15, 2021
Topics: 0 / Replies: 15
Reply
RE: BLTouch doing absolutely nothing on my Ender3 v2

Been there as well. You forgot the Z-Offset (which I find a pain in the ass)

1 year ago
Reply
RE: Ender 3 V2 – Bed level changes in between prints

make sure your x-gantry is not sagging or suffering from z-backlash

1 year ago
Forum
Reply
RE: OH, The Firmware! Where in the world to get the correct firmware???

your best shot is compiling from Marlin and adjusting parameters as to your needs. Since you can toast your printer with wrong settings, I’d not re…

2 years ago
Topic
Forum
Replies: 1
Views: 189
Reply
RE: Ender 3 v2 Hot End Fan Upgrade

correct assumption 🙂 I actually have a Buck Converter with voltage display for each fan mainly because I worried that one fan might get scaled down a…

2 years ago
Forum
Reply
RE: Ender 3 v2 Hot End Fan Upgrade

I’m using Noctuas 4020 for hotend and part cooling 24/7 for a month now. No problems at all. I just print PLA at 200°. I’m glad I went for it. I can…

2 years ago
Forum
Reply
RE: Change flowrate during print

use M221 if attached to pc/octoprint. Otherwise you can adjust the % at the printer. That does a M220, which adjusts not only flowrate but also the fe…

2 years ago
Forum
Topic
Replies: 2
Views: 1257
Reply
2 years ago
Forum
Reply
RE: My Ender3 v2 USB port not working

Does your windows detect a new device once you plug the printer? You can check 5v and ground by removing power from printer PSU and connecting just us…

2 years ago
Forum
Reply
RE: pls help me with ender 3 v2 bltouch

I can +1 on j2walker2. I wanted to give everything back until I noticed I had not set the Z-offset after adding the BLTouch check Marlin’s FAQ …

2 years ago
Forum
Reply
RE: Ender now only emits continuous beep when powered on.

Having this as well with precompiled nightly since 08.01. tested ROM from 08.01, 13.01, 14.01 > all same behaviour. Flashing back previous rom from…

2 years ago
Forum
Reply
Answer to: Not sticking to glass build plate

I fought 5 days with a new ender 3 V2. First 3d printer ever. Was about to call it Hewlett Packard. Some things I’ve noticed: – X-axis gantry wi…

2 years ago
Topic
Forum
Replies: 2
Views: 1872