Forum


 

EnderTiberius
EnderTiberius
@endertiberius
Active Member
Joined: Dec 16, 2020
Last seen: Dec 29, 2020
Topics: 0 / Replies: 7
Reply
RE: Ender 3 V2 with v4.2.7 board extruder runs backward

I eventually got this working with my own build. It’s necessary to set: #defineINVERT_E0_DIR true This firmware service is proving useles…

2 years ago
Reply
RE: Does the firmware builder use the same base options as the canned builds?

If you’ve identified a group of options as useful/appropriate for the nightly builds, wouldn’t it make sense to include them in the builder though? It…

2 years ago
Reply
RE: Add Support for M206 Command

I used the firmware builder on 12/15 to configure for Ender 3 V2 100 K Semitec 104 GT-2/104 NT-4R025H42G thermistor Hotend Max 285 Firmware ret…

2 years ago
Reply
RE: Does the firmware builder use the same base options as the canned builds?

Thanks for the clarification. I had a feeling that was the case, and not all of the features set on the nightly build page are options in the firmware…

2 years ago
Topic
Replies: 3
Views: 515
Topic