Forum


 

brodygoble
brodygoble
@brodygoble
Active Member
Joined: Dec 8, 2020
Last seen: Jan 20, 2021
Topics: 0 / Replies: 19
Reply
RE: Layer Shift, Ender 3 V2

Hi @doasaun, I am assuming you have left the mainboard enclosure wide open so it has a way to vent the warm are from the area? Will the printer do …

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Very interesting regarding timeframe everyone has ordered. I ordered mine near the end of November and at this time I could not find anyone else with …

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Yes it’s very frustrating, at this point I wish I had purchased anything other than the V2 as it seems this is some sort of flaw/defect that we are ex…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Try it before wasting any more time rebuilding it and going over it countless times like I did haha. Must be a bad batch of stepper drivers or somethi…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

To further add, I’ve just checked the provided tracking for the mainboard (first warranty tracking was for the bowden tube fittings in which the track…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Let us know if opening up the mainboard area to further ventilate helps the issue, it really is unfortunate. I was able to get back printing but occas…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

@dzlqw4 they did send me tracking for a replacement mainboard but I have yet to see it. I believe it is being shipped from China and unfortunately I c…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

SOLVED! As suspected, shifting and alignment issues were caused by a faulty mainboard that is very susceptible to heat soak. The Creality fan setup is…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

@eli-liu thanks, it was bought directly through this website, creality3d

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

@eli-liu yes, all motors rotate by hand perfectly and when printing they do not seem to be overly hot. I can leave my hand on them for reference witho…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

@eli-liu when we start looking at the random stopping mid print issues and freezing it only makes sense that the mainboard and stepper drivers are the…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Okay, more interesting progress on the problem. Since leaving the unit keep the bed heated at 60c to not release the printed project and have to start…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Hello, I have done further testing and exhausted more ideas. I’ve changed SD cards and also still having bizarre inconsistent prints. While I ca…

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Hi Eli, Just did a 300% Z XYZ cube and the result is again perfect. I am back to trying my square to circle larger transition duct again and …

2 years ago
Forum
Reply
RE: Layer Shift, Ender 3 V2

Thank you Eli, I am going to do a taller XYZ cube now for you.

2 years ago
Forum
Page 1 / 2