Forum

 

Notifications
Clear all

Setting Nozzle Temperature


BrianA
(@briana)
New Member Registered
Joined: 2 months ago
Posts: 3
Topic starter  

I have a constant problem when starting every print (including repeating the same design). The nozzle temperature setting goes to zero and I have to wind the knob up to get 200 degrees or whatever. The bed temperature goes to its proper default.

I have checked each design on the slicer - 200 is selected ok. I have also worked with two firmware versions - ex-factory and BL Touch (then back to ex-factory) - but same problem every time. 

My board is v4.2.7

This topic was modified 2 months ago 2 times by BrianA

ReplyQuote
Topic Tags