Forum

 

Notifications
Clear all

Printing Challenge


dburniston
(@dburniston)
New Member Registered
Joined: 8 months ago
Posts: 1
Topic starter  

I have downloaded the CE3PRO_Bed_Level_190x190.gcode file and can print a successful test 2 times in a row but when I then try to print another project it isn't sticking to the bed and the print is unsuccessful.

 

I'm using PrusaSlicer for the other projects. Could there be something in the G-Code generated that is setting a different Z location that is higher than the g-code for the test?

 

I have tried the a number of times. Test works fine but other project won't print. If I put a layer of painter tape down, the project file prints fine so it seems the spacing is different.

 

...Dave


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 9 months ago
Posts: 1045
 

@dburniston Hi, Dave. Yes, that is the reason. Different sd cards (Because setting change store in SD card ), different slier software may cause different Z starting locations. I have met these kinds of problems.


ReplyQuote