Forum

 

Notifications
Clear all

[Sticky] Print starting only trom left corner


Grappling
(@grappling)
New Member Registered
Joined: 5 months ago
Posts: 2
Topic starter  

My new Ender 3 V2 starting print only from left corner. Why this?  Is bad firmware? Slider ? Ver. of motheboard 4.2.2, firmware 1.6.5. how can I solution? Help me . 


ReplyQuote
Soutzen
(@soutzen)
New Member Registered
Joined: 5 months ago
Posts: 1
 

You meen the first stripe on the left?

That is exacly what supposed to happen te first strike, after that the print starts.

Ender 3 v2
CR touch sensor
500 mW laser module


ReplyQuote
Adalgeus
(@adalgeus)
New Member Registered
Joined: 3 months ago
Posts: 2
 

I have this same problem. It started quite soon after I had put the printer together, but it printed the first calibration cube all right.

The stripe on the left prints normally, but then the printer starts to print the object much smaller on the left corner/ on the home position than the one I sliced with the Creality Slicer. I tried different SD cards too, with different settings for the printable object, but no such luck.

 

Edit: The problem seems to be with the "origin at center" setting. When I removed it, my printing problems got solved.

This post was modified 2 months ago by Adalgeus

ReplyQuote