Clear all

[Sticky] Print starting only trom left corner

3 Posts
3 Users
New Member
Joined: 1 year ago
Posts: 2
Topic starter  

My new Ender 3 V2 starting print only from left corner. Why this?  Is bad firmware? Slicer ? Ver. of motheboard 4.2.2, firmware 1.6.5. how can I solution? Help me . 

New Member
Joined: 8 months ago
Posts: 4

something glithced 

Active Member
Joined: 6 months ago
Posts: 15

It sounds like your Ender 3 V2 is starting prints only from the left corner, which could be due to a few different factors. Here are a few suggestions that may help you resolve the issue:

  1. Calibration: Ensure that the print bed is calibrated properly. If the bed is not level or the X-Y axis is not calibrated, the printer will not print properly.

  2. Slicer Settings: Check the slicer settings to ensure that the print is starting from the correct origin. You may need to adjust the starting point or origin in your slicer settings.

  3. Firmware: If the issue persists, consider updating the firmware to the latest version. Newer versions of firmware often resolve bugs and improve performance.

  4. Motherboard: If the issue is not resolved, you may need to upgrade the motherboard to the latest version.

If you are still unable to resolve the issue, you may want to consider seeking help from the manufacturer or a local 3D printing community. They will be able to provide more specific and in-depth guidance to help resolve your issue. My Insite Login

This post was modified 1 month ago by Ericmurray