Creality 3D Printing Resources Forum

Forum

 

Forums
General Discussion
Ender-3 Series
Ender 3 V2
TroubleShooting(Pri…
Print job jogs
 
Notifications
Clear all

Print job jogs

TroubleShooting(Printing Help)
Last Post by kevin 2 years ago
4 Posts
2 Users
0 Likes
774 Views
RSS
gbartley
 gbartley
(@gbartley)
Active Member
Joined: 2 years ago
Posts: 8
Topic starter 05/05/2021 10:38 am  

Not sure where to start on this one and I am hoping that someone has seen this before. The print starts normal but as it climbs it starts to jog off to the right.

Any assistance is appreciated!

 


   
ReplyQuote
Topic Tags
jogs
kevin
 kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
06/05/2021 11:15 am  

@gbartley This is too serious! Have you checked the belts tight enough? Or the synchronizing wheel is not locked.


   
ReplyQuote
gbartley
 gbartley
(@gbartley)
Active Member
Joined: 2 years ago
Posts: 8
Topic starter 06/05/2021 10:55 pm  

@kevin

In a closer look of my friends computer I noticed that he z axis belt on rib side out. I had him switch the belt and now he’s good to go. 

Thanks for the response @Kevin!

 

Gerald


   
ReplyQuote
kevin
 kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
07/05/2021 9:58 am  

@gbartley You are welcome ? ? 


   
ReplyQuote
Forum Jump:
  Previous Topic
Next Topic  
Topic Tags:  jogs (1) ,
Share:
Tweet
Share
Share
Share
Share