Forum


 

Notifications
Clear all

Objects start waving or bending after a while!

1 Posts
1 Users
0 Likes
217 Views
Dan Lepage
(@dan-lepage)
New Member
Joined: 6 months ago
Posts: 2
Topic starter  

Hi, I’m new to this so I’m sorry if this is common and I’m just not aware of it.

My filament will stick well to the bed when printing but if my peace is long, it will start waving after a while. See picture. Is my bed too hot or too cold?
Current setup is : First layers 205/65, Following layers :195/55.

I did try different temp. with roughly the same results. Of course, many bed leveling were made also.

(Note: Sorry if this is not clear, English is my 2nd language)

EDIT: I start to understand it might be what is called “Warping”… I’ll read about that and see. 

This topic was modified 6 months ago by Dan Lepage

   
ReplyQuote