Notifications
Clear all

Nozzle hits bed, unable to level bed


hybotics
(@hybotics)
New Member Registered
Joined: 2 months ago
Posts: 1
Topic starter  

Hi,

I just got my first 3D Printer, an Ender 3 V2, but am having a lot of trouble with it. I was able to get one decent print from it after I finished assembling it. Something happened and now I can not get the bed leveled at all and the nozzle hits the bed whenever I try to autohome it.

It is the same whether I use the BLtouch or the hardware z-stop (not at the same time, of course). I have the Creality BLtouch kit that does not have the split cable on the mainboard end.

Is this fixable?

8-Dale


ReplyQuote
kevin
(@kevin)
Prominent Member Admin
Joined: 5 months ago
Posts: 918
 

@hybotics The Ender3v2 default mainboard is V4.2.2, so the Bl-touch without the split cable on the mainboard end is correct. Which firmware did you flash?


ReplyQuote
Scroll Up