Forum

 

Notifications
Clear all

Ender 3 v2 Print Issue


bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

I printed the attached file and noticed an issue on one side of the print see attached photo.

Not sure what is causing this issue, can someone help to advise

Ive also attached the gcode from cura for this print


ReplyQuote
bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

Tried pritinh it again but instead of standing it vertically i printed it horizontaly on the bed.

The results were not good


ReplyQuote
bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

Tried pritinh it again but instead of standing it vertically i printed it horizontaly on the bed.

The results were not good


ReplyQuote
bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

Image from another angle


ReplyQuote
bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

Another image from under the print


ReplyQuote
bobster316
(@bobster316)
Eminent Member Registered
Joined: 5 months ago
Posts: 20
Topic starter  

Another image from under the print


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@bobster316   Whare is your attached Gcode file? I did not see it. Thanks for sharing.

Do you have photos from other angles?  You can take the whole model from a little bit further away, I would like to see if the top is suspended.


ReplyQuote