Creality 3D Printing Resources Forum

Forum

 

Forums
General Discussion
Ender-3 Series
Ender 3 V2
TroubleShooting(Pri…
Ender 3 V2 Layer Sh…
 
Notifications
Clear all

Ender 3 V2 Layer Shift/Banding issue

 
TroubleShooting(Printing Help)
Last Post by kevin 2 years ago
5 Posts
2 Users
0 Likes
966 Views
RSS
 everettg03
(@everettg03)
New Member
Joined: 2 years ago
Posts: 3
Topic starter 31/07/2021 2:39 am  

I have this banding issue or layer shifting issue that I cannot figure out.

I printed with TPU for the first time so my temps were a little high. And after going back to some eSun PLA+ I keep getting this issue. I’ve printed probably 5 of these blocks at different layer heights with CHEP profiles and standard CURA profiles.

I’ve done esteps calibration and replaced my PTFE tubing with some new capricorn tube. Can anyone please give me some trouble shooting tips!?


   
ReplyQuote
Topic Tags
banding ribbion layer shi
 everettg03
(@everettg03)
New Member
Joined: 2 years ago
Posts: 3
Topic starter 31/07/2021 2:40 am  

here is another picture


   
ReplyQuote
kevin
 kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
31/07/2021 9:55 am  

@everettg03  It is likely that the belt is loose.


   
ReplyQuote
 everettg03
(@everettg03)
New Member
Joined: 2 years ago
Posts: 3
Topic starter 02/08/2021 8:12 pm  

@kevin I did check all my belts first and they are all tight. Can you suggest any other troubleshooting tips please?

Thank you for helping!


   
ReplyQuote
kevin
 kevin
(@kevin)
Noble Member
Joined: 2 years ago
Posts: 1045
03/08/2021 9:31 am  

@everettg03  https://forums.creality3dofficial.com/community/ender-3-v2/layer-shift-ender-3-v2/ There are many people got the same issue. You may find some tips here.


   
ReplyQuote
Forum Jump:
  Previous Topic
Next Topic  
Topic Tags:  banding ribbion layer shi (1) ,
Share:
TweetTweet
ShareShare
ShareShare
ShareShare
ShareShare