Notifications
Clear all
Topic starter
22/11/2021 4:07 am
Good evening everyone!
I've just bought my 1st 3DP, the E3v2, and was very excited to get something done, so levelled the bed and started printing a start.
1st try - after a couple of minutes, the 1st layer is not sticking anymore.
2nd try - print directly after the 1st disappointment without changing ANYTHING in the printer (neither slicing, nor levelling), result is "OK"
3rd try - print directly after the 2nd w/o changing anything, disappointment.
Does anyone have an idea why I am getting different results (KO-OK-KO) w/o changing anything between prints?
Thanks a lot in advance!
Take care,
Corn