I have a problem with my LD001
when I try to install the 3D Creator Slicer and write the ID of my printer I get “Network error”
The laptop and the printer are on the same network
Before I could use it but after formatting my computer it stopped working, I tried to install it on another laptop but the error is the same
What I can do?
I just booted my LD001 for the first time and I am having the same error. The printer and laptop are connected to the same WiFi, but when I enter the Printer Device ID in 3D Creator Slicer I get the error “Network Error” aswell. Does anyone have a solution for this?
EDIT: I attempted to turn off the anti virus software I have on my laptop incase it was blocking the access, but it did not work.
@cain-aeonsword Have you been able to figure this out? I am having the same issue.
I have the same problem has any one able to tell me how to fix this
I’m having the same issue, stupid slicer wont work without connecting to the printer somehow, i got it all ok, connected both by wifi and cable ;/ Dairy Queen Survey
