Clear all

Under extrusion?

1 Posts
2 Users
Topic starter

Printer is Ender 3. Filament is Ender PLA, Cura slicer with default PLA temp settings for bed and hot end. Printer seems to be under extruding, but I’m not 100% sure that’s the issue (it doesn’t always spit out material, but I’ve only been at this a couple months). After looking a bit online, I have replaced my nozzle (I couldn’t get the other one clean in a timely fashion and just popped in the other one that shipped with my printer) and ive also changed the print settings to change my extrusion multiplier all the way to 115%. I’ve been able to make some pretty nice prints with this printer in the past, so I don’t think it’s a bed leveling issue. Pic attached is my first layer. Any thoughts or solutions would be greatly appreciated. Thanks!

kevin kevin 28/07/2021 5:50 pm

The picture shows you that you have a blockage in the head of the hot nozzle.