Forum


 

Prints failing, new…
 
Notifications
Clear all

Prints failing, new to this

1 Posts
2 Users
0 Likes
800 Views
0
Topic starter

I have an ender3v2 and i set it up.
I downloaded the little boat that everyone seems to use as a test print, ran it through creality slicer with the default settings and their test filament and when i try to print it fails pretty much straight away.  the first layer seems to adhere to the bed lightly and then it just produces mess everywhere.
Any ideas, or recommended settings or even a simple youtube video to follow

kevin kevin 19/06/2021 10:20 am

It is very easy, I can see that the filament did not stick on the bed tight enough as there is a little gap between the filament. You can make your nozzle and bet closer.