Notifications
Clear all
0
11/07/2021 5:40 pm
Topic starter
Hello,
Recently my printer(CR10S) stopped in the middle of a print with te error: "MINTEMP: bed". What could the problem be? The thermistor still reads accurate temperature but sometimes a negative temperature appears after which the printer shows the error. Could it be a foulty connection or is it the motherboard? Or even a firmware problem?
Thanks in advance for the help.
If there is a negative temperature, no doubt that somewhere for the thermistor wiring is the disconnect. Creality thermistor type is NTC, the lower the temperature, the greater the resistance.