Notifications
Clear all

LD002-R - Build Plate Issues

   RSS

0
Topic starter

Hey All,

When beginning to print after initial clean up and build plate levelling as per instructions. The printing begins with the print plate going into the VAT, then it rises up higher than previous times. 

This is causing a build up of cured resin stuck to the bottom of the VAT. I have tried cleaning up releveling but still same issue. 

As this machine is new and I am new to everything, is this an easy fix? do I have to recalibrate the level again? what do you guys think? 

As you can appreciate it is painful cleaning the vat and I hope I am not causing damage?

 

I am looking forward to someone's advice.

 

Cheers

Pnutzy1982

Scroll Up