Notifications
Clear all
0
07/07/2021 3:27 pm
Topic starter
Recently bought your BL Touchkit for my Ender 5 pro (Creality 1.1.5 Board).
Followed the supplied instructions to the point where you use ISPROG.exe to check/set the low value, high value and ext value.
However, upon clicking Read or Write I get the following error:
Chip Enable Program Error
I doublechecked the items below:
– I made sure I have the ATmega1284P selected
– The USB ISP and USB ASP icons are in color (the usb device is detected?)
– The motherboard of the printer has the blue light on.
Any idea what is wrong or how I can successfully flash the new software to the board?