Notifications
Clear all
2
11/11/2021 3:08 am
Topic starter
Hello,
As many of you have probably done, you can pause the 3D printer manually using the knob and user interface. I assume that the selection you make (Pause or Stop) sends G-Code to the printer via the user interface, I have been wondering what this G-Code could possibly be as the postprocessing stop at Z height script does not work for my needs, and I figure I can make my own script that uses the same G-Code commands as the manual method.
So what I am asking is, where can I find the G-Code associated with the manual commands? Do I download some firmware from Creality or something and take a look there?