Forum

 

Notifications
Clear all

Ender 3 BL Touch Z Axis Setup help

   RSS

0
Topic starter

I have an Ender 3 Pro with the stock 4.2.2 board in it. I just picked up a genuine BL Touch kit and installed it. I updated the firmware with V4.2.2-Ender-3 Pro-32bit Mainboard-Marlin2.0.1-V1.3.1- BLTouch.bin and it seems to be fine. However I cannot manage to set the Z Axis though. When I hit auto home it goes to the middle of the build plate and sets at z 10. I ran through figuring out the offset number but the instructions say to look at Control >Motion Z Axis and I don't have that. The directions that came with the kit were horrid for this part. I am stuck, any help would be appreciated.

Thanks

Which BL touch cable you have, the 5 in 1 or 3+2 pins. Did you remove the Z limit switch connection? 

I have exactly the same problem- it arrived today. 

mine’s the 3+2 version and so the 2 replaced the z limit switch connection 

The control> motion> Z-axis just doesn’t appear as it shows in the video