Notifications
Clear all
0
27/12/2021 9:05 pm
Topic starter
hello
I was trying to install a BL Touch on my ender 3 pro 4.2.2 board, however when i connected the two BL Touch cables to the board it caused smoke, after updating the board firmware to an enabled BL Touch version i tried again, same thing however after a second attempt the screen went blank after the smoke and now it will not turn on?
I have looked at the board and power supply and everything is good thee, I have also swapped the screen cable to a different port on the screen and i have also tried reverting back to the factory marlin but still nothing.
I am new to this so any help would be great
Thanks
Adam