Clear all

Unable to engrave using Laser Kit in Black/White Mode of Workshop

New Member Registered
Joined: 10 months ago
Posts: 1
Topic starter  

Hi Guys,

I have a ender 3 pro with laser kit, laserkit engraves outlines pretty well but when I try to use black and white mode this is what I get (Photo Attached).

How can I fix this? I am using Creality WorkShop with settings as follows:

Laser on CMD: M106
Laser Off CMD: M107
CNC Travel Z: 100 mm
CNC Print Z: 100 mm
Travel Speed: 120 mm/s
Laser Speed: 15 mm/s

Can someone please help me... 

Thank You

This topic was modified 10 months ago by mustafa

Noble Member Registered
Joined: 1 year ago
Posts: 1045

@mustafa This may be a firmware issue. Please reflash this firmware. 

This post was modified 10 months ago 2 times by kevin

New Member Registered
Joined: 5 months ago
Posts: 3

Hi, my images looks like that. Its a part of big letter O. You can see that laserer stops in a proper position but starts with a delay like some capacitators inside head should charge after 24v is on from mainboard fan port. Speed of engraving is 15mm/s. What can I do? I'm using creality engraver 500mw, original printer software and Creality workshop.