Forum

 

Notifications
Clear all

Nylon printing help


Stemy
(@stemy)
New Member Registered
Joined: 4 months ago
Posts: 1
Topic starter  

I just got some Overture easy nylon. I printed a small bushing and after measured everything. the height of it was spot on but the o.d. and i.d was off. the o.d was off .003" on larger part and on smaller section it was off .012". The i.d was off .012". all was smaller than actually size needed. 

I can't find setting for this filament. Has anyone used this before? Looking to see what layer height i should use on it. 

The filament has a accuracy of  +/- .05mm.

I was just thinking i was sitting to low and it was extruding the lines wider that it suppose to. 


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 10 months ago
Posts: 1045
 

@stemy  You can lower the temperature of the hot nozzle a little.


ReplyQuote