Notifications
Clear all
Topic starter
29/04/2021 8:56 pm
Hi,
I've just received my ender 3 V2 from Banggood but one of the JST XH connector is broken.
I think it's the wire for the X axis limit switch.
See images attached.
Do you think i can easily repair the withe plastic part (i don't know yet if the cable himself is dammage but it seems ok)
I find this kit on amazon, is that the good connectors ?
Do i absolutly need a special tool to do so ?
Thank's !
This topic was modified 1 year ago by nowmad
Topic starter
30/04/2021 3:21 pm
@kevin Thank's !
Yes maybe it's better to take the pliers with the connector even if i think that the wire by itself is ok. It seems that is just the plastic part that is broken.
But i'll figure it out when the build will be finished.