Notifications
Clear all
General Discussion/Announcement
5
Posts
5
Users
0
Likes
677
Views
Topic starter
13/02/2022 9:54 am
Trying to understand if I have a filament problem or a printer problem. The first 3-4 layers of a print works just fine but the corners begin curl up and the nozzle breaks the entire print loose from the bed of the printer. The bed has been leveled. Then checked 4-5 times to make assure that it’s level. The bed is cleaned as well.
28/04/2022 3:07 pm
The first three or four layers of a print function well, then the corners begin to curl and the nozzle breaks the whole print free from the printer bed. Afterwards, the bed was tidied up.
03/05/2022 5:53 pm
What material are you using and what bed temperature?
11/07/2022 3:19 pm
Before printing, have you checked to see if the paper is stuck together gartic phone
This post was modified 7 months ago 2 times by RoseHeathcote
05/10/2022 12:37 pm
I use cotton fabric, and still no problem with my bed pou
This post was modified 4 months ago by krampusdecorous