Auto Home

First post and replies  | Last post by PenstonA, 4 months ago

Print bed collides with power supply, unable to level bed

First post and replies  | Last post by kevin, 12 months ago

Filament wont stick to the bed. Adhesion problem.

First post and replies  | Last post by helenberniced, 2 weeks ago

First few layers print good but corners come off of base

First post and replies  | Last post by AJL, 2 weeks ago

Bestand niet zichtbaar op de printer

First post and replies  | Last post by Zwaluw-zwijndrecht, 2 months ago

Dead-Ender3 For Me :0

First post and replies  | Last post by 3DPlearner, 3 months ago

Creality Cura 4.8.2 - Per Model Settings Missing

First post and replies  | Last post by RavenUK, 4 months ago

Getting machine setup properly

First post and replies  | Last post by KArthur1, 4 months ago

Very first 3D printer

First post and replies  | Last post by tk007b, 4 months ago

After one year, motors do not move

First post and replies  | Last post by shawnerz, 4 months ago

I just dont understand this.

First post and replies  | Last post by Anarky, 4 months ago

First time 3D printing - should I leave filament in the printer between prints?

First post and replies  | Last post by oneseventeen, 5 months ago

How to change filament mid print - because out of filament

First post and replies  | Last post by oneseventeen, 5 months ago

Unable to engrave using Laser Kit in Black/White Mode of Workshop

First post and replies  | Last post by sashimi, 5 months ago

Always different z-axis leveling

First post and replies  | Last post by Luramax, 5 months ago