Hello to all,
I’m new here and I found some good posts here.
Since msome weeks I own a Crreality Laser Module.
Now I would like to start engraving and use the CralityWorkshop tool.
It works quiete good. Thanks to the designer!
What I miss is any way to scale and place a picture by inputing values.
Is there a way to do this?
Thanks a lot in advance!
With kind regards
Kurt
@k-str Hello Kurt. Thanks for your nice comments.
The interface for Crealityworkshop is very simple. Please find the attached picture, I highlighted the scale place in green.
@kevin Hi Kevin,
thanks a lot for your answer.
But I miss a way how to change the size and offset of a picture.
I cannot change the values in the green framed controller area (see attachment).
What means there the radio button 0.1 mm; 1.0 mm; 10.0 mm?
@k-str That’s weird. Here, I can change the value in the green framed controller area.
0.1 mm; 1.0 mm; 10.0 mm means you can change the offset by clicking the X+,X-,Y+,Y- buttom, 0.1 mm; 1.0 mm; 10.0 mm/on click.
If you can not do these, it could be a problem with your photo or the software. ?
