Forum

 

Notifications
Clear all

motherboard issues


PhilH
(@philh)
New Member Registered
Joined: 2 months ago
Posts: 1
Topic starter  

i was having problems geting my ender 3v2 to work i could not flash the firmware on the motherboard (had the 4.2.2) so i ordered a new board and got the 4.2.7 installed it and printed a benchy. after that i pulled the card (with the power off) put on another print i wanted to start put the card back in and started the print (14 hour print) there was nothing on the printer after about 4 hours and the print said 0%. dial was not responsive to stop print and i turned off the power. the screen came back up but would not load so i did a reflash of the mother boad now i can see the logo but do not get a loading bar and it will not boot past the logo

 

PLEASE HELP ME 


ReplyQuote