Forum

 

Forums
General Discussion
Ender-3 Series
Ender 3 V2
Firmware/Software H...
Home offset
 
Notifications
Clear all

Home offset

    Last Post
  RSS

BZRBEE
 BZRBEE
(@bzrbee)
New Member Registered
Joined: 6 months ago
Posts: 3
Topic starter 15/04/2021 9:43 am  

I was trying to use the bl  touch firmware(marlin FW 1.30 Jyer  Builds) and it would not save any settings. So i went back to the stock verified firmware(Ender-3 V2-Marlin-2.0.1 - V1.0.1-2020.6.2) .

When i went back to the stock firmware the home offset just beeps.

I want to just use the stock firmware.

Anyone know how to fix this issue?

This topic was modified 6 months ago 2 times by BZRBEE

ReplyQuote
CYT
 CYT
(@cyt)
Eminent Member Registered
Joined: 8 months ago
Posts: 46
15/04/2021 11:50 am  

I think the beep sounds mean that you flash the wrong firmware. If you want to get the default firmware, maybe you can go to this page and download the

Ender-3 V2_4.2.2 Marlin-2.0.1 – V1.0.2 (Factory Firmware) Verified

version on your sd card and plug it in the printer to flash the firmware. 

https://forums.creality3dofficial.com/download/ender-series/ender-3-v2/.

you can also go to the same page, and download the corresponding bl touch firmware. 


ReplyQuote
BZRBEE
 BZRBEE
(@bzrbee)
New Member Registered
Joined: 6 months ago
Posts: 3
Topic starter 15/04/2021 8:30 pm  

@cyt

That is the one i used. Just reflashed and same thing.


ReplyQuote
  All forum topics
  Previous Topic
Next Topic