Forum

 

Notifications
Clear all

Bltouch doesn't work when changing build plate size


theoneoflife
(@theoneoflife)
New Member Registered
Joined: 2 months ago
Posts: 1
Topic starter  

I recently installed the ender extender kit that brought my print size up to 400mm x 400mm x 450mm. When trying to edit the firmware, I could flash the printer, but never could get it to actually level properly with the touch. when the leveling process would start, it would just extend the probe, then when it touched, the touch would blink and it would continue to move down until the nozzle crashed or I killed the power. when I re flashed it with my old firmware ( standard size and BLtouch) ith would fine, just in a smaller space. please assist, I would be most greatful


ReplyQuote
kevin
(@kevin)
Noble Member Registered
Joined: 7 months ago
Posts: 1045
 

@theoneoflife I don't think it's enough to update the print size somewhere, there should be some kind of code associated with it, but unfortunately I don't know anything about it.


ReplyQuote