Notifications
Clear all
May 10, 2021 5:03 am
I have an Ender 3 MAX. It worked fine out of the box. I used the builder to create firmwaree for mesh bed levelling…everything worked great, menus and all…Except t6he runout sensor stopped working. I tried building with the sensor set to LOW and also with it set 5to HIGH. Neither option solves the problem. Any ideas?
1 Reply
May 10, 2021 2:33 pm
@nightmyst The problem is in the firmware, your new firmware has no instructions for filament runout sensor. What is the version of your mainboard? Do you have a bl-touch? Creality has a little firmware for Ender3 max. Not sure if I can help.
