Notifications
Clear all
Firmware Builder
2
Posts
2
Users
0
Likes
989
Views
Nov 09, 2021 6:41 pm
I have been using the BL Touch on a 32 bit motherboard without issues. Now I have installed the Micro Swiss direct extruder and I need to adjust the X and Y origins. To do that, I need to tweak the source code of course, but the only source code that I can find is the original factory code and not the latest version with BL Touch support.
Where can I find the latest source code please?
1 Reply
Nov 09, 2021 7:28 pm
Informative post.