Notifications
Clear all

Firmware Builder / Bilinear Bed Leveling


ipe
Posts: 2
 ipe
Registered
Topic starter
(@ipe)
Nozzle
Joined: 1 month ago

Hi,

 

Enderer 3 V2 with BLtouch and Bilinear Bed Leveling. Just builded new firmware with this. When i start Level from machine, what is first point to measure when doing it? Cause its seems to go 0 0 and then BLTouch is not on a plate. Homing works OK either separate or at the begining of level.

 

am i missing something?

 

br ipe

 

Reply
3 Replies
1 Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 4 months ago

Stepper Motor
Posts: 192

@ipe Likely you'll need to set the probe to nozzle offset via the M851 command:

https://marlinfw.org/docs/gcode/M851.html

Once you have this right, when you home, the PROBE will be in the centre of the bed - not the nozzle.

Reply
ipe
Posts: 2
 ipe
Registered
Topic starter
(@ipe)
Nozzle
Joined: 1 month ago

Why firmware builder wont store right values to firmware when BLTouch is selected?

 

Anyone know if this "Enable Probe Offset Wizard" is supported in Enderer 3 v2?

 

Reply
1 Reply
Marlin Firmware Service
(@marlin-firmware-service)
Joined: 4 months ago

Stepper Motor
Posts: 192

@ipe I'm not sure what you mean about the right values.

The Ender 3 V2 display doesn't currently support the probe offset wizard.

Reply
Scroll Up